Heads up: kits are AI-designed and haven't been test-built. Parts may not fit together or match your hardware as-is — expect to adjust holes, clearances or dimensions. Print one part and dry-fit it before printing the rest or buying hardware.*
Whole builds, not just parts
Each kit is a complete robotics project: every printed part designed to fit together, the screws and electronics you'll need, assembly steps, and a render of the finished machine. Order the whole kit printed in one click, or download every file at once.
- Parts share one set of dimensions
- Hardware list included
- Add the whole kit to your cart
NEMA17 Leadscrew Push-Pull Actuator
A compact linear actuator for props and animatronics. A NEMA17 turns a T8 leadscrew, and a carriage on twin 8 mm rods pushes and pulls through a clevis with about 120 mm of travel.
SG90 Animatronic Eye Mechanism
A two-servo animatronic eye rig. Two 30 mm eyeballs pan and tilt together on printed gimbal yokes, driven by a pan servo through a scotch yoke and a tilt servo through a slotted paddle.
SG90 Four-Axis Desktop Robot Arm
A 4-axis desktop robot arm that runs on four SG90 servos. It has a turning base, a shoulder carried on a 625 bearing, an elbow and a geared parallel gripper. There are eight printed parts.
SG90 18-DOF Hexapod Walker
A six-legged walker with 18 SG90 micro servos, fitted to one set of tolerances: chassis, deck, battery tray and a three-part leg that repeats six times.
SG90 Scotch-Yoke Flapping Wing Rig
A single SG90 servo drives a Scotch-yoke slider on a 624 roller that flaps two bolt-on bat wings in sync, about ±37°. Build it into a dragon, bat or bird.
SG90 Wheeled Serpentine Snake Robot
A 440 mm snake robot with four yaw joints. Each joint is an SG90/MG90S servo with a 624 bearing underneath, and passive wheels let it slither forward with a travelling sine wave.
MG90S Animatronic Desk Lamp Robot
A Luxo-style robot lamp that pans, nods and looks around. It runs on four MG90S/SG90 servos, with 624 bearings supporting the opposite side of every joint and slotted servo plates for alignment.
MG996R 12-DOF Quadruped Robot Dog
A Spot-Micro-style 12-servo robot dog on a 2020 spine, with 625-bearing supported shoulder and knee joints and adjustable servo fits, all built from six printed parts.
SG90 Tendon-Driven Continuum Trunk Arm
A soft-robotics "elephant trunk": eight rolling-dome vertebrae on a PTFE backbone, bent in any direction by three SG90 servos pulling tendons through Bowden guides.
MG996R Heavy Pan-Tilt Camera Gimbal
A two-axis pan-tilt gimbal for phones, action cams and compact cameras. It runs on two MG996R metal-gear servos, with a 624 roller track and a 608-supported tilt axis carrying the load.