Heads up: kits are AI-designed and haven't been test-built. Parts may not fit together or match your hardware as-is — expect to adjust holes, clearances or dimensions. Print one part and dry-fit it before printing the rest or buying hardware.*
Whole builds, not just parts
Each kit is a complete robotics project: every printed part designed to fit together, the screws and electronics you'll need, assembly steps, and a render of the finished machine. Order the whole kit printed in one click, or download every file at once.
- Parts share one set of dimensions
- Hardware list included
- Add the whole kit to your cart
N20 4WD Skid-Steer Rover Base
A printed 4WD skid-steer rover for four N20 gearmotors, with a 2S 18650 cradle, a raised Raspberry Pi 4 deck and a front bumper with a sensor grid.
NEMA17 Twin-Motor Strandbeest Walker
A four-legged Theo Jansen walker at 2x scale. Each side has its own NEMA17, so it steers like a tank. It uses M4 pivots and a numbered layer stack so the separately printed links line up.
SG90 18-DOF Hexapod Walker
A six-legged walker with 18 SG90 micro servos, fitted to one set of tolerances: chassis, deck, battery tray and a three-part leg that repeats six times.
NEMA17 Rocker-Bogie Mars Rover Chassis
A six-wheel rocker-bogie rover chassis with a NEMA17 driving each wheel directly, 608-bearing pivots and a differential bar that keeps the deck level over rough ground.
SG90 Ackermann Steering Rover Chassis
A car-style rover with real Ackermann geometry: one SG90 steers the front knuckles through a trapezoid tie bar, and two N20 gearmotors drive the rear wheels.
NEMA17 Geneva Indexing Turntable
A NEMA17 stepper drives a 6-slot Geneva wheel that turns a 140 mm platter in exact 60° steps and locks it firmly between moves. Runs on two 608 bearings on a fixed 8 mm rod.
MG996R 12-DOF Quadruped Robot Dog
A Spot-Micro-style 12-servo robot dog on a 2020 spine, with 625-bearing supported shoulder and knee joints and adjustable servo fits, all built from six printed parts.