Heads up: kits are AI-designed and haven't been test-built. Parts may not fit together or match your hardware as-is — expect to adjust holes, clearances or dimensions. Print one part and dry-fit it before printing the rest or buying hardware.*
Whole builds, not just parts
Each kit is a complete robotics project: every printed part designed to fit together, the screws and electronics you'll need, assembly steps, and a render of the finished machine. Order the whole kit printed in one click, or download every file at once.
- Parts share one set of dimensions
- Hardware list included
- Add the whole kit to your cart
N20 4WD Skid-Steer Rover Base
A printed 4WD skid-steer rover for four N20 gearmotors, with a 2S 18650 cradle, a raised Raspberry Pi 4 deck and a front bumper with a sensor grid.
SG90 Scotch-Yoke Flapping Wing Rig
A single SG90 servo drives a Scotch-yoke slider on a 624 roller that flaps two bolt-on bat wings in sync, about ±37°. Build it into a dragon, bat or bird.
NEMA17 Rocker-Bogie Mars Rover Chassis
A six-wheel rocker-bogie rover chassis with a NEMA17 driving each wheel directly, 608-bearing pivots and a differential bar that keeps the deck level over rough ground.
SG90 Ackermann Steering Rover Chassis
A car-style rover with real Ackermann geometry: one SG90 steers the front knuckles through a trapezoid tie bar, and two N20 gearmotors drive the rear wheels.
MG996R 12-DOF Quadruped Robot Dog
A Spot-Micro-style 12-servo robot dog on a 2020 spine, with 625-bearing supported shoulder and knee joints and adjustable servo fits, all built from six printed parts.
SG90 Parallelogram-Leg Biped Walker
A 4-servo biped whose parallelogram legs keep the ankles level. It leans with ankle-roll servos and steps with hip-pitch servos, so walking takes 4 SG90s instead of 12.