Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.
A screw-on wall holster that hangs a cordless drill or impact driver by its body shoulder: an 80 x 62 mm back plate with four M4 clearance holes (4.5 mm) carries a 60 mm deep shelf with a 46 mm wide throat for the grip, gusseted so the load runs in-plane instead of across layer lines. Two 10 mm front lips on the side rails stop the drill sliding out, and the whole thing prints flat on its back with no bridges or supports.
A handheld drill guide with five tall bushing towers (3.2, 4.2, 5.2, 6.4 and 8.2 mm) that keep a bit perfectly perpendicular, plus a 90° V-groove underside that self-centers the holes on dowels and round stock. Block is 102 x 36 x 44 mm.
A slip-on soft jaw cap for a bench vise: the tapered channel wedges onto jaw plates 12.5–16.5 mm thick, and crossed 90° V-grooves cradle round bar either horizontally or standing upright. 80 mm long, 30 mm tall — print two, one for each jaw.