Heads up: kits are AI-designed and haven't been test-built. Parts may not fit together or match your hardware as-is — expect to adjust holes, clearances or dimensions. Print one part and dry-fit it before printing the rest or buying hardware.*
Whole builds, not just parts
Each kit is a complete robotics project: every printed part designed to fit together, the screws and electronics you'll need, assembly steps, and a render of the finished machine. Order the whole kit printed in one click, or download every file at once.
- Parts share one set of dimensions
- Hardware list included
- Add the whole kit to your cart
NEMA17 Belt-Drive Camera Slider
A motorized camera slider on twin 8 mm rods. A NEMA17 drives a GT2 belt, and a four-LM8UU carriage carries the camera for smooth time-lapse and video moves.
NEMA17 Leadscrew Push-Pull Actuator
A compact linear actuator for props and animatronics. A NEMA17 turns a T8 leadscrew, and a carriage on twin 8 mm rods pushes and pulls through a clevis with about 120 mm of travel.
SG90 Animatronic Eye Mechanism
A two-servo animatronic eye rig. Two 30 mm eyeballs pan and tilt together on printed gimbal yokes, driven by a pan servo through a scotch yoke and a tilt servo through a slotted paddle.
N20 4WD Skid-Steer Rover Base
A printed 4WD skid-steer rover for four N20 gearmotors, with a 2S 18650 cradle, a raised Raspberry Pi 4 deck and a front bumper with a sensor grid.
NEMA17 Cantilever Pen Plotter
A GRBL pen plotter: two NEMA17s drive a cantilevered X arm on 8 mm rods and LM8UU bearings, with a guided, SG90-driven pen lift. Draws up to 240 x 260 mm.
SG90 Scotch-Yoke Flapping Wing Rig
A single SG90 servo drives a Scotch-yoke slider on a 624 roller that flaps two bolt-on bat wings in sync, about ±37°. Build it into a dragon, bat or bird.
N20 Twin-Track Mini Tank Chassis
A skid-steer mini tank with print-in-place 12 mm-pitch tracks built to match its 12-tooth sprockets. Two N20 gearmotors drive it and a 2x18650 deck powers it.