Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
An oversized 78 mm split escutcheon that clamps onto a 1/2 in NPS shower arm (21.3 mm OD) to hide the chipped drywall or tile hole left after an arm swap — the stock 50 mm flange never covers it, and you can't buy a split one without a whole arm kit. It prints as one piece: a 1.2 mm living-hinge ligament at the rim lets the two halves swing open around the arm in place, then one M3x20 screw through the 3.4 mm lug into the 2.6 mm self-tap pilot pulls the 21.8 mm bore tight. 78 mm dia x 16 mm tall, 2.6 mm brim, print in PETG.
Replacement side-wall channel clip that carries a 1/4 in (6 mm) glass shelf in an old steel or wood medicine cabinet, for when the original stamped clips are long discontinued. The 90 x 22 x 16 mm body has a 6.8 mm wide, 12 mm deep channel with a flared lead-in and a closed back stop, plus two 3.4 mm M3 clearance holes 70 mm apart on tabs clear of the jaws so a screwdriver reaches; the flat 4 mm back also takes VHB tape if you can't drill the cabinet. Symmetric about its centreline, so the same print flipped over serves the opposite wall — print two.
A 120 mm replacement flush lever arm for a toilet tank, for when the brittle OEM arm snaps at the chain hole and the linkage isn't sold separately. Instead of guessing your handle's tab shape, a 14 mm deep forked jaw slides over the handle blade (1.5–3.6 mm thick) and pinches it with an M3×20 screw and a captured M3 nut; five 4 mm chain holes on a 12 mm pitch set the flapper chain length. Arm cross-section is 5 × 12 mm so the bending load runs along the print's strong axis.
A split collar that clamps onto a standard 1/2" NPT shower arm (21.3 mm OD pipe) with one M4 screw into a heat-set insert, carrying two 30 mm upturned J-hooks for a loofah, razor strap or bottle handle — no suction cups, no drilling tile. Collar bore is 21.8 mm, ring wall 3.5 mm, overall 60 x 38 x 18 mm; slide it on with the shower head removed, then pinch the 3 mm gap closed to lock it.
A 140 x 95 mm riser shelf that slides in around a bathroom sink drain so the dead space beside the P-trap becomes usable storage — the 52 mm wide U-slot (26 mm end radius) clears common 1-1/4 in and 1-1/2 in tubular tailpieces and their slip nuts. Four hollow 18 mm legs give 45 mm of clearance over the cabinet floor, 7 mm drain slots let a drip pass straight through instead of pooling under your bottles, and each foot has a 4.5 mm M4 clearance hole if you want to screw it down.
A countertop vanity dispenser: a 61 mm tube that stacks standard cotton rounds with a full-height front slot so you can see the level and pull one out with a thumb, plus an attached 28 mm cup for cotton swabs. Footprint 98 x 66 mm, 82 mm tall.
A winding key that grips the flat tail of a toothpaste or ointment tube in a 3.2 mm slot; twist the finger-hole knobs to roll the tube up and push every last bit out. 96 mm long with a Ø7 mm hang hole in one knob.