Print-ready 3D models

Under-Desk Power Strip Cradle

A screw-up bracket that lifts a power strip (or a laptop brick) off the floor and onto the underside of a desk or bench: two 15° V-arms self-centre any body 38–52 mm wide, and a 4.8 mm zip tie cinches it down through four slots, its loop hidden in a 2.2 mm groove milled into the desk-facing side so the plate still sits flat. 68 x 32 mm footprint, 31 mm tall, two 4.5 mm counterbored holes on 26 mm centres for M4 or #8 screws. Print two and space them along the strip.

⚠ Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.

Desk Side Mug And Tumbler Holder

A screw-on cradle that hangs a drink off the side panel, apron or leg of a desk so it can't be knocked into the keyboard. The tapered socket runs Ø78 mm at the floor to Ø89 mm at the rim and is 32 mm deep, which wedges mugs, tumblers and 500 ml bottles while smaller cans sit on the floor; a 32 mm slot lets a mug handle hang out the front and a Ø44 mm floor hole drains condensation and pushes a stuck cup back up. Mounts with four M4 screws (4.5 mm clearance) on a 38 x 12 mm pattern set above the ring so a driver can reach them. Overall 96 x 102 x 60 mm.