Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Stepped Radial Capacitor 12-Cell Sort Tray
A 150 x 105 mm tray with 12 cells in three tiers. Walls stand 22, 32 and 42 mm tall, giving pockets 20, 30 and 40 mm deep, each about 35 x 33 mm. The tall cells hold radial electrolytic caps (5x11 mm up to 13x25 mm), legs and all, which won't fit in shallow resistor trays. Every cell has a 45° scoop ramp at the front so you can slide parts out with a finger, and the vertical step faces on the two back tiers take value labels.
Radial Lead Five-Pitch Forming Jig
This bench jig has five forming blades for bending the leads of radial parts like LEDs, electrolytic capacitors and TO-92 transistors. It spreads the 2.54 mm factory lead spacing to 3.5, 5.08, 7.62, 10.16 or 12.7 mm (perfboard 2-5 hole pitch). Each blade is the target pitch minus 0.6 mm wide, which leaves room for the lead itself. You press the part down over the chamfered blade top, and the leads end up parallel and spaced right. The 10 mm blade height plus the deck gives every lead the same trim length. The base is 90 x 44 mm and the jig is 14 mm tall overall.