Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
DIP IC Lead Straightener Block
A 110 x 44 x 10 mm bench block with two open-ended straightening channels. Press a new DIP chip into one of the 45° lead-in grooves and its splayed legs get pushed back to parallel, so it drops straight into a socket or breadboard. The narrow channel is 8.0 mm wide for 300-mil (7.62 mm row) DIP-8 to DIP-28, the wide channel is 15.6 mm for 600-mil (15.24 mm row) DIP-24 to DIP-40, and a centre thumb notch helps you lift the chip back out.
Flexure DIP Chip Extractor Tweezer
A one-piece flexure tweezer for pulling DIP chips (roughly DIP-8 to DIP-28, 0.3 in body) straight out of sockets. Its 1.6 mm hooks slip under both ends of the chip so the pins come out without bending. At rest the hook tips are 36 mm apart, and built-in squeeze stops keep them from closing tighter than about 7 mm, so you can't pinch the chip body. The whole tool is 100 x 50 x 6 mm, prints flat and has a 5 mm hole for hanging it on a pegboard hook.
DIP And SOIC IC Tube Lane Rack
A 158 x 45 x 60 mm upright rack for anti-static IC shipping tubes (partial or full). It has ten boxed lanes, each 14 mm deep: two 20 mm lanes for wide DIP-600, four 14 mm lanes for DIP-300 and four 10 mm lanes for SOIC. Each lane has a 12 mm front lip and a top retaining bar, with an open window between them so the part number printed on the tube stays readable. Screw it to the wall through two 4.5 mm holes in the back, or to a shelf through the 45 mm foot plate. The lanes are made loose so tubes from different makers fit. Measure your tubes before ordering.