Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Universal Doorbell Button Cover Plate
This 46 x 110 x 14 mm hollow-back faceplate replaces a cracked wired doorbell button. It covers an old wall cutout up to 40 x 104 mm and takes a 16 mm panel-mount momentary pushbutton in a 16.2 mm through-bore, with a drip hood above it. Two 4.4 mm reinforced slots fit #6 (3.5 mm) or #8 (4.2 mm) screws at any spacing from 40 to 84 mm, so it lines up with old holes. A notch in the bottom wall lets surface-run bell wire in.
Video Doorbell 30 Degree Wedge
A 30° horizontal-aim wedge that sits between a video doorbell or small security camera and the wall, swinging the field of view across an offset walkway or corner entry — 46 mm wide, 84 mm tall, tapering from 5.2 mm to 31.8 mm deep. Six 4.5 mm through-holes on the centreline (M4 or #6 screws) give nine bracket spacings from 28 to 68 mm, a 26 x 16 mm pass-through carries the bell wires, and the hollow shell is symmetric so flipping it end-for-end aims the other direction.