Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pi 4 Edge-On DIN Rail Snap Mount
This mount holds a Raspberry Pi 4B or 3B+ edge-on to a standard 35 mm TH35-7.5 DIN rail (1 mm flanges). The board sits on four M2.5 standoffs on the 58 x 49 mm hole pattern and stands at right angles to the rail, so it takes up roughly 25 mm of rail instead of 85 mm. On the 92 x 87 mm plate, a fixed hook grips one rail flange, a flexure latch snaps over the other, and you release it by twisting a flat screwdriver in the slot.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
mmWave Sensor Corner Wedge Mount
A hollow 90° corner column that aims an mmWave presence sensor (Aqara FP2/FP1, LD2410, generic 24 GHz modules) diagonally across a room instead of into one wall. 56 x 56 mm footprint, 60 mm tall, with a 79 mm wide 45° front pad, a gusseted ledge 18 mm up for the sensor to rest on, two 4.5 mm strap slots, a 10 x 10 mm cable port into the hollow interior, and four M4 clearance holes through 6.3 mm ribbed bosses for drywall anchors. The corner vertex is relieved 3.5 mm so drywall corner bead or tape buildup doesn't rock the mount.