Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Multimeter Belt Clip Strap Holster
A belt clip for a handheld multimeter. The meter sits on a cradle ledge with a 46 mm inside depth and is held by a 25 mm hook-and-loop strap threaded through two 26 x 4 mm slots, so it fits most handheld DMMs whatever their width. The 6 mm spring-tongue clip (narrowing to 3.5 mm at the bump) slides over belts up to 50 mm wide and about 3–5 mm thick, and it prints on its side so the clip flexes along the layers instead of peeling them apart.
Eight-Lane Test Hook Clip Comb Stand
A 90 mm wide, 50 mm tall bench stand with eight tapered sockets on a 10.5 mm pitch. Each socket narrows from 8.5 mm at the top to 4 mm and is open at the bottom, so test hook clips and grabber probes of different body sizes drop in and wedge upright with their leads hanging free. The 45-degree comb bar and end gussets print without supports, and two 3.4 mm holes let you screw it to the bench with M3 or #6 wood screws.
Universal Multimeter Tilt Stand With Probe Holsters
A replacement for the snap-off kickstand on a cheap multimeter. The meter sits in a 96 mm wide cradle against a 16 mm front lip and leans back 30° on a gusseted rest, so any meter up to 96 mm wide and about 45 mm thick fits without needing its own dimensions. Two 10.5 mm holsters at the sides hold test probes with grips up to 10 mm across. The stand measures 134 x 104 x 80 mm, and the backrest and floor have cut-out windows to save plastic.