Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
DIN Rail Terminal Block End Stop
Screw-lock end stop / partition barrier for 35 mm top-hat DIN rail (EN 60715 TS35, 7.5 mm hat, 1.0–1.5 mm flange): hooks reach 2.3 mm behind both rail flanges and two M3x16 screws self-tap into 2.6 mm holes to jack the body off the rail and lock it solid, so terminal blocks stop sliding and wires stop pulling at the crimp. 42 mm wide x 35.4 mm tall x 10 mm thick (one block width), with a 10 x 4 mm cable-tie slot at the top for anchoring the wire bundle.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
Acrylic Panel Enclosure Corner Post
A corner post for building custom project boxes out of 3 mm acrylic, plywood or scrap FR4: the side panels slide into two 3.3 mm grooves (3 mm stock + 0.3 mm clearance, 19 mm engagement) and the base and lid screw into M3 brass heat-set inserts at each end (4.0 mm bore, 6 mm deep). Post is 50 mm tall with 30 mm legs, 9 mm thick; print four and cut panels to whatever size your PSU, amp or controller board needs.