Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Vented PCI Slot Blanking Plate
This printed cover replaces a lost or bent PC case expansion-slot cover. It uses the standard full-height ATX/PCI bracket size, 120 mm long and 18.4 mm wide, with a tapered 10 mm bottom tongue and an 11.4 mm top foot. The foot has a U-notch that slips under a loosened 6-32 or M3 case screw, so you don't need to remove the screw. Ten vent slots and two stiffening ribs on the inside face keep the 1.2 mm plate flat, and they leave the outer face plain so it sits flush against the rear panel.
Snap-Off PC And Console Foot Set
This is a set of four tapered 34 mm feet, 12 mm tall, joined by thin snap-off bridges. They replace the lost feet on PC towers, consoles, amplifiers and project boxes, and lift the case back up off the desk so the vents can breathe. Each foot fastens with an M3 screw through a 3.4 mm clearance hole. The screw head sits in a 6.5 mm counterbore under a 14 mm × 2 mm recess, where you can stick a rubber bumper. The top face is flat, so you can also use VHB tape if there's no screw boss.
PC Chassis Edge Snap Cable Dress Clip
A screwless cable clip that pushes onto any 0.8–2.0 mm sheet-metal edge, like a PC case rail, a server chassis lip or an enclosure cutout. Its tapered wedge slot narrows from 2.2 mm to 0.6 mm and pinches the panel. On top it has three snap-in C-channels with 7.3, 5.3 and 4.3 mm bores, for coax up to about 7 mm, USB/SATA round leads and fan wires. The clip is 42 x 26 x 15 mm and prints flat, so the snap rings and prongs flex in the strong XY plane.