Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pi 4 And Pi Zero Nut-Track Project Box
A 120 x 80 x 32 mm project box. Its 4.2 mm floor has four captured M3 nut tracks spaced for both the Raspberry Pi 4 (58 x 49 mm hole pattern) and the Pi Zero (58 x 23 mm), so you can bolt a board anywhere along the tracks. It has cable notches in both ends, vent slots in the side walls and four M3 heat-set insert bosses (4.0 mm bore, 8 mm deep) for screwing on a flat lid.
Pi Zero To Pi 4 Footprint Adapter Deck
A 66 x 57 mm adapter plate that lets you mount a Raspberry Pi Zero on a robot deck already drilled for a Pi 4B/3B+. It bolts down through the Pi 4's 58 x 49 mm M2.5 pattern and has four 5 mm standoffs on the Zero's 58 x 23 mm pattern, so you can switch boards without re-drilling the chassis.
DIN Rail Pi Zero Snap Mount
A 66 x 44 mm adapter plate that snaps onto standard 35 mm top-hat DIN rail (TS35) and carries a Raspberry Pi Zero / Zero 2 W on its front face via the 58 x 23 mm hole pattern, plus two spare M3 holes for any other small module. One rigid hook grabs the first rail flange; a 30 mm sprung tongue with a pull tab grabs the second, so boards clip on and off the rail in a second without unscrewing anything — ideal for putting hobby sensors and controllers into a real home-automation or garage panel.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.