Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Power Strip Zip-Tie Wall Cradle
This wall cradle gets a 6- to 12-outlet power strip or surge protector off the bench floor. Mount two of them and the strip sits in a 48 mm deep x 95 mm tall pocket behind an 18 mm front lip, held by a zip-tie that loops through two slots in the shelf, so any strip body up to 48 mm deep fits. It screws to the wall with two #8 (4.2 mm) wood screws through slotted 4.6 mm holes with recessed heads. It prints on its side so the shelf load runs along the layers, and under-shelf gussets carry the weight.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
Three-Bay Wall Wart Brick Shelf
A screw-to-wall or under-desk tray with three 48 x 75 mm bays, 32 mm deep walls, that holds bulky wall-wart and inline power bricks away from the power strip, so they stop covering the sockets next to them. Each bay has a front notch for the DC lead, a rear notch for the AC cord and floor vents. It mounts with two #8 (4.2 mm) wood screws through 5 mm holes in the 4 mm back wall. Overall size is 154 x 81 x 34 mm.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.