Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Network Switch Jack-Screw Wall Cup Pair
A U-cup wall bracket that grips one end of a desktop network switch or router. Print two: mount one under the device and one upside-down above it. The 36 mm channel takes gear 8–34 mm thick, and an M4 screw in an M4 heat-set insert (5.5 mm bore) in the front lip clamps the case against the back. Each cup fixes to the wall with two #8 or #10 screws through 5.5 mm holes below the floor, so the screw heads stay clear of the device and nothing depends on the case's own (usually missing) keyholes.
Mesh Wi-Fi Node Wall Cradle
A 155 x 58 x 76 mm wall and ceiling cradle for mesh Wi-Fi nodes (Eero, Deco, Nest Wifi Pro) — routers ship with no mount at all, so nodes end up on the floor where coverage is worst. The bay is 145 mm wide x 48 mm deep with a 14 mm front lip and side arms, hangs on two keyhole slots 40 mm apart, has two 4.5 mm M4 clearance holes for screwing it down hard (ceiling use), 4 x 40 mm vent cutouts under the node, a pair of 4 x 12 mm zip-tie strap slots, and an 18 mm cable exit through the backplate.