Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Gridfinity 1x1 Four-Cell Half-Grid Bin
A standard Gridfinity 1x1 bin (41.5 x 41.5 mm, 3 units / 21 mm tall, no stacking lip) split into four 18 x 18 mm cells on a 21 mm half-grid pitch. Each cell has a 45° scoop ramp at the front. It gives desk and bench Gridfinity grids the finer sorting that SMD parts, small screws and connectors need, without moving to a non-standard baseplate.
Four-Reel SMD Tape Wall Rack
A 150 x 32 mm wall plate with four 12.4 mm pegs on 30 mm centres that hang 7 inch (178 mm) SMD component reels by their 13 mm EIA-481 arbor hole, so you can pull tape one-handed at the bench. Pegs stand 36 mm proud on a tapered root and tilt 5 degrees upward so loaded reels stay put and clear the wall; four 4.5 mm holes take M4 or #8 wood screws, and a 10 x 3 mm slot under each peg pinches the tape end so the reel can't unwind.
Hinged SMD Stencil Paste Jig
A print-in-place hinged jig for applying solder paste through an SMD stencil: the 95 x 80 mm base deck has a 70 x 50 mm pocket 1.6 mm deep that holds a standard FR4 board flush with the deck, and a 95 x 62 mm frame folds over on a 5 mm print-in-place hinge so the stencil stays registered while you squeegee. Two 11 mm ejection holes push the finished board out from below, and two M3 clearance holes tie the jig down to the bench.
Cut Tape SMD Strip Rack
A terraced 9-channel rack that stands loose cut-tape strips of SMD passives on edge so they stay readable and stop unspooling in a drawer. Channels are a uniform 4.6 mm wide (paper or embossed carrier) but stepped in depth — 5 mm for 8 mm tape at the front, then 7, 9 and 13 mm for 12, 16 and 24 mm tape at the back — so every strip protrudes by roughly half its width. Body is 144 x 65.4 x 16 mm, holds strips up to 117 mm long, with a 125 x 8 mm front face for a label strip and two M3 clearance ears (3.4 mm, 130 mm apart) to screw it to a shelf or bench back.