Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
DIP IC Lead Straightener Block
A 110 x 44 x 10 mm bench block with two open-ended straightening channels. Press a new DIP chip into one of the 45° lead-in grooves and its splayed legs get pushed back to parallel, so it drops straight into a socket or breadboard. The narrow channel is 8.0 mm wide for 300-mil (7.62 mm row) DIP-8 to DIP-28, the wide channel is 15.6 mm for 600-mil (15.24 mm row) DIP-24 to DIP-40, and a centre thumb notch helps you lift the chip back out.
Axial Lead Bending Pitch Jig
A 136 x 26 x 14 mm bench jig for forming the leads of axial through-hole parts (1/4 W resistors, diodes, small caps) to exact PCB hole pitch: lay the body across a rib, press both leads down the sides, and the lead centres land on the 2.54 mm grid. Six ribs give 5.08, 7.62, 10.16, 12.7, 15.24 and 20.32 mm (0.2–0.8 in) pitches — each rib is milled 0.6 mm under its pitch so the bent lead diameter makes up the difference — with 3 mm relief slots through the 4 mm base so long leads pass clear, and two M3 clearance holes 122 mm apart for bolting it to the bench.