Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Single-Gang Pre-Terminated Cable Pass-Through Plate
This single-gang wall plate (70 x 114 mm, the 2.75 x 4.5 in standard size) has a 28 x 20 mm port that a moulded RJ45 plug or F-connector can pass through. An 8 mm side slit lets you slip the plate over Cat6 or RG6 that is already pulled, so you don't have to cut off factory connectors. The screw holes are slotted 4.2 mm wide over 79.5–83.8 mm centres, which covers the standard 83.3 mm (3-9/32 in) spacing of US device boxes and low-voltage brackets with #6-32 screws.
Universal Doorbell Button Cover Plate
This 46 x 110 x 14 mm hollow-back faceplate replaces a cracked wired doorbell button. It covers an old wall cutout up to 40 x 104 mm and takes a 16 mm panel-mount momentary pushbutton in a 16.2 mm through-bore, with a drip hood above it. Two 4.4 mm reinforced slots fit #6 (3.5 mm) or #8 (4.2 mm) screws at any spacing from 40 to 84 mm, so it lines up with old holes. A notch in the bottom wall lets surface-run bell wire in.