Print-ready 3D models

Register Vent Air Deflector Clamp

A 150 mm wide, 50°-angled deflector blade that screw-clamps onto the outermost louver fin of a floor, wall or ceiling HVAC register to throw supply air away from curtains, a bed or a sofa instead of straight up the wall. Two clamp posts take an M4 heat-set insert (5.5 mm bore) and an M4 set screw that pins any fin up to 12 mm thick against an 8 mm anvil, so it works on stamped steel and moulded plastic registers alike — unlike magnetic deflectors that slide off. Blade is 2.6 mm thick with three full-length stiffening fences; overall 150 x 69 x 66 mm, prints rail-down with no supports.