Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
A replacement end bracket for the bottle-retainer bar on a refrigerator door bin: it slides over the bin's top edge, grips walls 2–5.5 mm thick with an M3 set screw in a heat-set insert (4.0 mm bore) plus two 45° bite ridges, and carries an 8 mm smooth rod or dowel in a teardrop 8.4 mm bore. Print two, cut a rod to the bin width, and skip the $40–60 whole-bar assembly that is discontinued on older fridges. Each bracket is 32.5 x 40 x 22 mm with a 40 mm long clamping jaw.
A screw-clamped replacement tine for a dishwasher rack: a split saddle grips any coated rack wire from 4.6 to 6.6 mm and carries a 48 mm tapered fin that holds plates apart where the original tines snapped or rusted through. 59 x 21 x 36 mm, closed by two M3 x 20 stainless screws into M3 heat-set inserts (4.0 mm bores), with six drain cutouts; print in PETG.
A tapered 1-cup (240 ml) scoop for dog food, birdseed, coffee beans or detergent, with a flat base so it stands on the counter and a 10 mm hole in the angled handle to hang it on a hook. Bowl is 129 mm long with 2.4 mm walls.
⚠ Flagged: contact with food. Not for safety-critical use without independent engineering review.