Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Twin-Slot Eye Tilt Paddle
The U-shaped tilt rocker (96 × 37 × 18 mm, black) for the 'SG90 Animatronic Eye Mechanism' kit. It pivots on the y -45 / z 30 axis between an SG90 horn and an M3x16 idler pivot. Its 3 mm crossbar has two 22 × 4.2 mm rounded slots on a 60 mm pitch that steer the M3x35 eye-stalk screws. The right arm has a flat outer face for the stock SG90 horn (2 servo self-tappers) and a Ø7 hole for screwdriver access. The left arm has a Ø3.4 hole for an M3x16 SHCS, washer and nylock.
Pan Scotch-Yoke Tie Bar
This is the red tie bar for the 'SG90 Animatronic Eye Mechanism' kit. It is 74 × 30 × 5 mm and connects both eye-yoke pan levers through Ø3.4 holes on a 60 mm pitch, using M3x8 SHCS and M3 washers. Its centre tongue has a 2.6 mm slot (end centres 14 mm apart) with 0.4 mm chamfers on both faces. The M2x16 pin on the SG90 pan horn runs in this slot, forming a scotch yoke that pans both eyes together.
Eye Gimbal Pan Yoke
A U-shaped gimbal yoke for the 'SG90 Animatronic Eye Mechanism' kit (print ×2). Each yoke holds one 30 mm eyeball so its pan and tilt axes cross at the centre of the eye. The 41 × 10 × 5 mm bottom bar pivots on the deck using an M3x16 SHCS, a washer and an M3 nylock through a Ø3.4 bore. The two 5 mm uprights have Ø3.4 tilt holes at z 29.5, 31 mm apart on their inner faces, and take M3x12 SHCS that screw into the eyeball. A +Y lever with an R7 pad has a Ø2.6 self-tap hole 20 mm from the pivot for the M3x8 tie-bar screw.