Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
A print-in-place tilt-out parts bin: an 87 x 47 x 60 mm wall frame with a 70 x 41 x 50 mm bin hanging on captured 5 mm axles, so the bin self-closes by gravity and tips forward to pour screws or SMD parts into your hand. Mounts with two M4 screws through 4.5 mm holes on 56 mm centres, placed above the bin so a driver still reaches them; prints as one piece with no supports and 0.5 mm clearance on every mating face.
A print-in-place hinged tilt bracket for small 10–100 W solar panels, 140 x 60 mm with a 5 mm base plate and a 60 mm-tall detent post. The base bolts to a roof rail, van rack or shed wall with four M5 lag screws (5.5 mm clearance holes) and the panel wing takes four M5 frame bolts; a single M5 x 60 bolt through the post and quadrant fin locks the tilt at 15°, 30°, 45° or 60°, with strap slots on both plates for frameless panels.
A 60 mm one-piece carabiner whose gate is a built-in flexing spring arm — press it inward to hook on, and a capture nose stops it opening under load. Prints flat with no supports, no assembly, and no metal spring; sized for keys, water bottles, and bag straps.
⚠ Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.