Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Module 1.5 Winch Worm
This is the self-locking worm for the 'N20 Self-Locking Worm-Drive Winch' kit. It is a single-start, right-hand, module 1.5 worm: 15 mm OD, 12 mm pitch diameter, 4.712 mm lead and a 7.1° lead angle. It has a 16 x 10 mm collar with a 3.1 mm bore, 10 mm deep, for the N20 3 mm D-shaft, which an M3x8 grub screw and captured M3 nut hold. Its 4 mm tail pin runs in a 624 bearing (4 x 13 x 5 mm). The overall length is 39 mm, and it prints standing on the collar face.
Print-In-Place 7-Link Track Strip
A 7-link, 12 mm-pitch print-in-place track strip, 28 mm wide and about 92 mm long, for the 'N20 Twin-Track Mini Tank Chassis' kit. Print 8 and join 4 into each 28-link loop. Each link has 8.4 mm knuckles and an integral 4 mm pin running in a 5 mm teardrop bore, plus a 5.6 x 7.6 mm window that the 12T sprocket teeth drive through. The strips join with M3x8 SHCS inserted from each track edge, passing through the last link's 3.4 mm bore and threading into the first link's 2.6 mm self-tap pilot.