Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Rotary-Disc Lettering Guideline Template
This is an Ames-style lettering guide: a 120 x 80 x 4 mm frame holding a 65 mm disc that prints in place and turns freely. The disc has three columns of 1.6 mm pencil holes: an even 4 mm pitch, a 3/5 lowercase ratio and a 2/3 ratio. Turn it to an index tick to set guideline spacing at 4, 3.5, 3, 2.5 or 2 mm, then put a 0.5 mm pencil in a hole and slide the frame along a T-square or ruler. The frame's 68° slant edge and 90° edge draw italic and upright slant lines.
Print-In-Place Contour Profile Gauge
A print-in-place contour (profile) gauge: 27 sliding pins on a 3.2 mm pitch copy an 86 mm wide profile up to 26 mm deep, so you can trace pipe, moulding, skirting or a tile cut-out straight onto the workpiece. Body is 110 x 18 x 48 mm with a 5.5 mm M5 clearance hole through one end post for hanging on a nail or pegboard hook; pins print standing on the bed inside a closed channel and drop to full extension when you hold it pin-side down.