Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place Gravity-Stow Folding Wall Hook
This print-in-place folding hook has a 120 x 44 x 10 mm wall plate. An 80 mm hook arm hangs flat in a window cut through the plate, so gravity keeps it stowed. When you need it, swing it out: it pivots on a 5 mm printed pin and stops a little past horizontal against the plate. That makes it useful in hallways, vans and closets where a fixed hook would snag you. The two 4.6 mm countersunk holes take #8 wood screws (4.2 mm shank) or M4 screws.
Print-In-Place Self-Levelling Gimbal Mount
This is a three-ring Cardan gimbal that prints in one piece. Two pairs of 5 mm pins sit 90° apart, so the 60 mm inner cup stays level on both axes while whatever it's bolted to tilts. That's useful for keeping a compass, a laser line, an IMU or a cup level on a boat, van or rover. The cup has four M3 heat-set bosses on a 30 mm square and a central M5 hole where you hang a ballast bolt. The outer ring is 96 mm across and mounts through M4 holes in the ears, which sit 110 mm apart. All rings have 1 mm of clearance and 0.5 mm around each pin, so the inner cup and middle ring can swing all the way round.