Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Flexure-Isolated IMU Sensor Deck
A 70 x 70 x 6 mm frame that bolts to a robot chassis with four M3 screws on a 62 mm square. A 30 mm floating platform is held by four serpentine flexures that isolate an IMU or compass board from motor vibration. The platform has slotted M2.5 holes, so it fits 2-hole boards at 12–22 mm spacing and square patterns from 8.5 to 22.6 mm.
Fin Ray Compliant Gripper Finger
A Fin Ray-style compliant gripper finger, 94 mm long × 30 mm deep × 22 mm wide, with a 3 mm contact beam, a 3 mm tapered spine and six 2.6 mm cross ribs, so the face wraps around whatever it touches instead of point-loading it. It bolts to any jaw carrier with two M3 socket screws on a 14 mm spacing through counterbored 3.4 mm holes (5.5 mm heads sink 12 mm deep); the part is mirror-symmetric, so print two identical fingers for a two-jaw gripper.