Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
NEMA 17 To MGN12H Carriage Angle Bracket
An L-profile bracket that mounts a NEMA 17 stepper (31 mm square M3 pattern, 22 mm pilot bore) on a 5 mm plate, next to a hollow 40 mm ribbed riser. The riser's 6 mm cap has the MGN12H carriage's 20 x 20 mm M3 pattern, so you can drive a wheel, pulley or leadscrew from a moving rail carriage. Overall size is 48 x 80 x 40 mm, and it prints without supports.
MGN12H To 2020 Cross-Beam Adapter
This adapter plate bolts to an MGN12H rail carriage (four M3 screws on a 20 x 20 mm square, heads counterbored below flush) and holds a 2020 extrusion crosswise in a 20.3 mm locating cradle. Four M5 T-nut bolts go into the extrusion: two up through the floor and two through the cradle walls. It is 64 x 28 x 23 mm and lets you build an X-gantry, camera slider or pick-and-place arm on a linear rail without a machined carriage plate.
MGN12H GT2 Belt Clamp Carriage
A 68 × 38 × 5 mm carriage plate that bolts straight onto an MGN12H block (20 × 20 mm M3 pattern, heads recessed in 6.2 mm counterbores) and clamps both ends of a 6 mm GT2 belt on 2 mm-pitch tooth ridges, held by a zip tie through the four 4 × 3 mm slots. Four M3 heat-set bosses (4.0 mm bore, 6 mm deep) on a 38 × 25 mm grid give a flat tool deck for a gantry head, sensor or gripper — the piece a linear-rail axis normally needs but the rail kit never includes.