Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Tilt Servo Side Upright
A 70 x 90 x 6 mm side upright for a tilt axis. It holds a standard MG996R-size servo in a 41.5 x 20.5 mm body window, with M4 tab slots on each side, and has a gusseted foot flange that takes two M3 screws (3.4 mm holes) to fix it to a chassis or pan platform. It prints flat with the inner face up, so the servo load runs along the layers instead of across them.
NEMA 17 To MGN12H Carriage Angle Bracket
An L-profile bracket that mounts a NEMA 17 stepper (31 mm square M3 pattern, 22 mm pilot bore) on a 5 mm plate, next to a hollow 40 mm ribbed riser. The riser's 6 mm cap has the MGN12H carriage's 20 x 20 mm M3 pattern, so you can drive a wheel, pulley or leadscrew from a moving rail carriage. Overall size is 48 x 80 x 40 mm, and it prints without supports.
NEMA 17 Homing Flag And Endstop Plate
A 5 mm plate that sits between a NEMA 17 stepper (31 mm M3 bolt square, 22 mm pilot) and whatever it's mounted to. It has an arm with slotted holes so you can slide a microswitch or optical endstop in or out to line it up. It prints with a flag collar for the 5 mm shaft (M3 set screw) attached by a snap-off tab, so a rotary joint or turntable can home to a repeatable position.