Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Magnetic 1:6 And 1:8 Dovetail Saw Guide
L-shaped hand-saw guide that hooks over the end of a board and holds a dovetail saw plate flat against a magnetic face angled 1:6 (9.5°) at one end and 1:8 (7.1°) at the other, so every tail and pin is sawn to the layout line with no drift. Takes six common 10 × 3 mm neodymium disc magnets (10.3 mm pockets, 3.2 mm deep, three per end, glue in flush), legs are 15 mm thick with 20 mm fences for stock up to 20 mm (3/4 in); 55 mm long, 43 mm high as printed. Use it from the far face of the board for the opposite lean and turn it 90° to saw pins. Six dimples mark the 1:6 end, eight mark the 1:8 end.
1:6 And 1:8 Dovetail Marking Gauge
A two-ratio dovetail marker. A 10 x 14 mm centre fence hooks over the board edge, and one of two trapezoid blades lies flat on the face. The 1:6 blade suits softwood and the 1:8 blade suits hardwood; both edges of each blade are at that ratio, so you can mark tails leaning either way without flipping the gauge. It measures 90 x 120 mm overall, the blades are 3 mm thick and 80 mm wide at the fence, and each blade has a 6 mm hang hole.