Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1/4 in Hex Bit Offset Stubby Wrench
A flat 133 mm wrench for getting into tight spots. One end has a 12-point socket for standard 1/4 in (6.35 mm) hex insert bits, so you can turn a screw inside a cramped appliance or chair housing in 30° swings where a screwdriver won't fit. The other end is a 6-point box end for M5 hex nuts (8 mm across flats). It prints flat at 9 mm thick, so the turning force runs along the layers, and it has an M4 clearance hole for hanging it up.
Ceiling Fan Blade Balancing Clip
A slide-on balancing clip for fixing a wobbling ceiling fan. Its flexing jaws grip blade edges 4–7 mm thick, and a hex well holds a stack of M5 nuts (8 mm across flats) as trim weight. Clip it to one blade at a time and slide it along the blade until the wobble stops. The nut count tells you how much weight to fix permanently. It's 48 x 15 x 20 mm and the jaws are printed flat, so they flex along the layers, not across them.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.