52 mm Gauge Pod Panel Mount
A single-hole pod for a standard 52 mm (2-1/16") boost, oil-pressure or volt gauge: Ø52.4 mm bore, 36 mm deep, stepping down to a Ø48 mm shoulder that stops the gauge and lets the harness exit straight through the base. The cup sits at 18° on a flat 92 x 78 x 5 mm plate with four M4 clearance holes (VHB-friendly underside), and two M4 heat-set inserts in the flank pads take nylon-tip set screws that lock the barrel — total height about 58 mm, prints on the plate with no supports.
electronics gauge-pod automotive m4-heatset
⚠ Flagged: automotive electrical. Not for safety-critical use without independent engineering review.