DIN Rail Terminal Block End Stop
Screw-lock end stop / partition barrier for 35 mm top-hat DIN rail (EN 60715 TS35, 7.5 mm hat, 1.0–1.5 mm flange): hooks reach 2.3 mm behind both rail flanges and two M3x16 screws self-tap into 2.6 mm holes to jack the body off the rail and lock it solid, so terminal blocks stop sliding and wires stop pulling at the crimp. 42 mm wide x 35.4 mm tall x 10 mm thick (one block width), with a 10 x 4 mm cable-tie slot at the top for anchoring the wire bundle.
electronics din-rail terminal-block end-stop
⚠ Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.