GT2 Toothed Belt Clamp Plate
This belt clamp plate is part of the 'NEMA17 Belt-Drive Camera Slider' kit. The 70 × 24 × 4 mm red plate clamps both ends of the 6 mm GT2 belt against the Quad LM8UU Camera Carriage's belt tab. A 7 mm band of 2.0 mm-pitch ridges (1.0 mm wide, 0.75 mm tall) meshes with the belt teeth so the belt can't slip. Four M3x12 screws pass through 3.4 mm holes on a 35 × 15 mm rectangle into the tab's M3 heat-set inserts. The holes sit above and below the belt band, so no screw goes through the belt.
robotics kit gt2 belt-clamp