M5 Screw Faucet Handle Puller
This is a one-piece jacking puller for removing seized single-lever faucet handles when you're replacing a cartridge. Two hook lips sit 34 mm apart and grip under handle hubs roughly 36–48 mm across. There is 50 mm of clear height under the crossbar. You drop a standard 8 mm M5 hex nut into the captured slot, then drive an M5 x 50 bolt down through the 5.5 mm bore onto the stem to push the handle off. The part is 66 x 72 x 14 mm and prints flat, so all the pulling load stays in the layer plane.
tool faucet puller plumbing