Pi 4 Slide-In Cluster Blade Sled
A 112 x 70 mm slide-in sled for a Raspberry Pi 4B/3B+. It has four 6 mm standoffs on the 58 x 49 mm hole pattern with 2.9 mm M2.5 through-bores and 6.4 mm nut/head recesses underneath. The 3 mm floor has vent slots and works as a 4 mm tongue down each side, so it slides into any 3.5 mm card-guide slot or rack groove. A finger-pull tab sits under the USB/Ethernet end, so you can swap cluster nodes without unscrewing anything.
electronics raspberry-pi pi-4 cluster
⚠ Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.