Pi HAT Pogo Pin Test Jig Base
A 96 x 80 x 14 mm pogo pin test jig base for Raspberry Pi HAT and pHAT boards. It has M2.5 locator holes on the 58 x 49 mm and 58 x 23 mm Pi patterns, and a 2.54 mm drill-guide grid (21 x 17 lines) where you drill holes to fit your own pogo pins. Four M3 heat-set bosses take a hold-down lid, and a raised skirt with a cable notch gives wire clearance underneath. It saves you from hand-holding probes every time you retest a homebrew board.
electronics pogo-pin test-jig raspberry-pi