Pi Zero Outdoor Sensor Node Gland Box
A wall-mount base tub for outdoor Home Assistant and garden sensor nodes. It measures 90 x 60 x 36 mm and has a 3 mm wall. Inside are Pi Zero standoffs on the 58 x 23 mm pattern with 2.9 mm M2.5 holes, counterbored from the back. Two 12.6 mm holes in the bottom wall take M12 or PG7 cable glands, so sensor leads come in from below and water runs away from them. There are four M3 heat-set insert bosses with 4.0 mm bores for the lid, a 3 mm flat rim for foam gasket tape, and slotted wall ears for #8 screws.
electronics raspberry-pi-zero enclosure cable-gland
⚠ Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.