Print-In-Place Flush Lift Ring Pull
A low-profile flip-up bail pull that prints already assembled: a 41 x 27.5 mm D-bail with 4.2 mm pivot pins sits in a 64 x 52 x 8 mm frame. Four counterbored 4.5 mm holes take #8 wood screws or M4 bolts. It gives van-life drawers, floor hatches, toolbox lids and sliding panels a pull that lies flat and won't snag. Every moving face has 0.5–0.6 mm of clearance, and the pivot is shaped so the bail never swings below the mounting face.
mechanism flush-pull print-in-place hinge