Print-In-Place Rope Turning Block
A surface-mount rope pulley with a 34 mm sheave that prints in place on its own 9 mm axle post — no bearings, no assembly. The V-groove takes 5–6 mm rope (clothesline, tarp ridgeline, ceiling hoist, kayak or gate pull line) and redirects it up to 180°; the 50 x 58 mm base screws down with four M5 / #10 wood screws through 5.5 mm holes, and the capture cap keeps the rope in the groove even when the line goes slack.
mechanism pulley rope print-in-place
⚠ Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.