Print-ready 3D models

Window Screen Push-In Pull Tab Set

A set of four replacement window screen pull tabs that push into the spline channel beside the rubber spline, replacing the vinyl tabs that crumble in the sun. Each tab is a 10 mm wide finger loop (15 mm outer diameter, 9.5 mm hole) on a 12 x 2.4 mm base that sits on the frame lips, with a 1.2 mm thick barbed leg in four lengths (5, 7, 9 and 11 mm) to suit shallow and deep channels around a 3.6 mm spline; the whole set prints flat on its side so layer lines run along the loop-to-leg bend and the tabs snap apart on 1 mm thick sprues.