Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.
A print-in-place ball-and-socket gimbal for cameras, lidar pucks and sensor boards on a robot or drone frame: a Ø20 mm ball captured in a spherical socket with a 0.4 mm gap gives 360° pan and roughly ±33° tilt, and one M4 thumbscrew driven into a brass heat-set insert (5.5 mm bore) locks the angle without any springs or shims. The 50 x 34 x 5 mm base bolts down with four M3 screws on a 42 x 24 mm pattern, and the 26 x 26 mm top plate carries four M3 clearance holes on a 18 x 18 mm square; overall 50 x 34 x 48 mm.
A 139 mm print-in-place centipede: eight leg-bearing body segments joined by seven captured ball-and-socket joints, so the whole body ripples and curls in your hand. Prints fully assembled, flat on the plate, no supports and no assembly.
A curved clip that wedges onto the rim of a 1-gallon paint can, giving you a clean edge to wipe your brush on and a slot to park it over the paint instead of on the rim. Spans a 50° arc of the can, about 74 mm wide.
A two-horn wall cleat for figure-eight wrapping an extension cord, air hose or rope, with flared post tips that keep the coil from slipping off. 120 mm wide, mounts with two countersunk screws and holds roughly a 50 ft 16-gauge cord.
A 60 mm one-piece carabiner whose gate is a built-in flexing spring arm — press it inward to hook on, and a capture nose stops it opening under load. Prints flat with no supports, no assembly, and no metal spring; sized for keys, water bottles, and bag straps.
A screw-on wall gripper whose springy C-jaws snap over a 20–26 mm broom, mop, rake or squeegee handle so it hangs off the floor. 60 mm back plate with two counterbored screw holes; 18 mm tall jaws with a 19 mm snap mouth.