Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.
A 144 mm desk plate with three real meshing gears — a 24-tooth crank wheel with a domed finger knob driving two 14-tooth pinions, all captured on mushroom-cap posts. Prints fully assembled, no supports: four separate pieces, 0.45 mm clearance everywhere, spin the knob and the whole train turns.
A 139 mm print-in-place centipede: eight leg-bearing body segments joined by seven captured ball-and-socket joints, so the whole body ripples and curls in your hand. Prints fully assembled, flat on the plate, no supports and no assembly.
A curved clip that wedges onto the rim of a 1-gallon paint can, giving you a clean edge to wipe your brush on and a slot to park it over the paint instead of on the rim. Spans a 50° arc of the can, about 74 mm wide.
A 60 mm one-piece carabiner whose gate is a built-in flexing spring arm — press it inward to hook on, and a capture nose stops it opening under load. Prints flat with no supports, no assembly, and no metal spring; sized for keys, water bottles, and bag straps.
A shelf that hangs on the center screw of a standard duplex outlet cover to hold a charging phone off the floor. 70 mm wide plate, 58 mm deep ledge with an 8 mm lip and a cord notch through the middle.
A screw-on wall gripper whose springy C-jaws snap over a 20–26 mm broom, mop, rake or squeegee handle so it hangs off the floor. 60 mm back plate with two counterbored screw holes; 18 mm tall jaws with a 19 mm snap mouth.