Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.
A print-in-place ball-and-socket gimbal for cameras, lidar pucks and sensor boards on a robot or drone frame: a Ø20 mm ball captured in a spherical socket with a 0.4 mm gap gives 360° pan and roughly ±33° tilt, and one M4 thumbscrew driven into a brass heat-set insert (5.5 mm bore) locks the angle without any springs or shims. The 50 x 34 x 5 mm base bolts down with four M3 screws on a 42 x 24 mm pattern, and the 26 x 26 mm top plate carries four M3 clearance holes on a 18 x 18 mm square; overall 50 x 34 x 48 mm.
A curved clip that wedges onto the rim of a 1-gallon paint can, giving you a clean edge to wipe your brush on and a slot to park it over the paint instead of on the rim. Spans a 50° arc of the can, about 74 mm wide.
A three-step cabinet riser that stair-steps spice jars so every label is visible from the front. 80 mm wide x 108 mm deep x 66 mm tall, with a 3 mm lip on each tread so jars can't slide off; hollow open-bottom shell with internal ribs to keep it light.
A 60 mm one-piece carabiner whose gate is a built-in flexing spring arm — press it inward to hook on, and a capture nose stops it opening under load. Prints flat with no supports, no assembly, and no metal spring; sized for keys, water bottles, and bag straps.
A screw-on wall gripper whose springy C-jaws snap over a 20–26 mm broom, mop, rake or squeegee handle so it hangs off the floor. 60 mm back plate with two counterbored screw holes; 18 mm tall jaws with a 19 mm snap mouth.