Preview in 3D, we print and ship it — or download the file to print yourself.
Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.
A 60 mm OD × 18 mm wide spoked drive wheel that slips onto any 5 mm motor shaft (NEMA 17, 37 mm gearmotor) and locks with an M3 set screw threaded into the 6.3 mm hub wall. The 8 mm × 2.5 mm rim groove seats a #64 rubber band as a tire, and 24 scallops in the flanges give traction if you run it bare — replaces the hub-and-tire set nobody stocks for one-off robot builds.
A desk dock with a recessed tray sized for a standard 76 x 76 mm sticky note pad and a rounded rear trough for pens, pencils and erasers. A scalloped thumb notch in the front wall lets you peel notes one-handed; footprint is 86 x 113 mm and 20 mm tall.
A 100 mm lazy-susan tray that prints as one piece and spins straight off the plate — the deck is captured by a mushroom post and rides on low-friction ring lands. Holds spice jars, sauces, pens or craft supplies in a 90 mm bowl with a 10 mm rim and eight grip ribs.
An open-top can that swallows a ball of jute or sisal twine (80 mm inner diameter, 80 mm deep) and feeds it out through a guide eyelet, with a pinch slot on the lip that grips the loose end so it never falls back inside. A keyhole on the flat back hangs it on a single screw in the shed or potting bench, or it just sits upright on the bench.
A two-compartment caddy that sits beside the faucet to hold a sponge and scrub brush separately, with slotted drain holes in the bottom so water runs out instead of pooling. Fits a standard sponge; overall footprint 100 x 70 x 45 mm.