Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Under-Desk 1/2 in EMT Foot Bar Bracket
A trussed side bracket that screws to the inside of a desk's legs or side panels with four #8 wood screws. Each bracket carries a length of 1/2 in EMT conduit (17.9 mm OD; the ring bore is 18.4 mm) as a foot bar under the desk. The 60 x 96 x 48 mm part is printed on its side, so foot load runs along the layers. An M4 self-tapping screw from below (3.4 mm pilot) pinches the tube so it doesn't spin.
1 in PVC Rocking Footrest End Stand
This is one end of an under-desk rocking footrest. Print two of them and join them with two lengths of 1 in schedule 40 PVC pipe (33.4 mm OD), which sit in 33.8 mm blind sockets 25 mm deep. You can fix each pipe with a #8 screw through the 4.5 mm cross holes or with PVC cement. The stand is 160 x 109 x 28 mm with an R260 rocker arc on the bottom and open windows to save plastic. It prints face-down, so foot load goes into the plate across the layers' strong direction instead of peeling them apart.