Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Interlocking Hex Pen Pot Cell 60 mm
A 60 mm across-flats, 70 mm tall hex desk pot with dovetail rails on three alternating faces and matching sockets on the other three. Any print slides into any other from above, so you can build a honeycomb of pen, scissors and tool cups that holds together as one block instead of sliding apart. Fit clearance is 0.25 mm per side, and the floor and walls are 2 mm thick, so each cell uses about 40 cm³.
60 mm Desk Grommet Pen Well With Cable Chimney
A pen well that drops into a standard 60 mm desk grommet hole. Lift out the stock grommet cap and press this in: it holds pens in the 72 mm-wide, six-cell ring, and a central 22 mm chimney still lets a charging cable come up through the desk. A 58.6 mm spigot with eight crush ribs (60.6 mm across the ribs) grips the hole, and a 45° conical seat centres on the hole edge. The spigot reaches about 16 mm down, so it suits desktops 16 mm or thicker.
608 Bearing Spinning Pen Carousel
An 84 mm wide, 50 mm tall pen and tool carousel with eight wedge bays and a 20 mm centre cup. A standard 608 bearing (8 x 22 x 7 mm) presses into a 22.05 mm pocket in the underside, so the carousel spins on any fixed 8 mm post, such as an M8 bolt standing in a scrap block or a piece of 8 mm rod.
Clip-On Notebook Pen Loop
This loop slides onto the edge of a notebook or planner cover and holds your pen along that edge. The spring jaws are 30 mm long and grip boards 1.5–3 mm thick, from card-cover journals to hardcovers. A split 10.5 mm ring grips 10–11.5 mm gel and ballpoint pens. The part is 43 x 15 x 30 mm, prints flat with no supports, and needs no glue or elastic band that can stretch out.
Business Card Stand With Pen Trough
This desk stand has a 92 mm wide card well tilted back 15°. It fits both US business cards (88.9 x 50.8 mm) and EU/ISO cards (85 x 55 mm), in stacks up to about 25 mm deep. The front has a thumb notch so you can pull out one card at a time, and a closed-end 12 mm pen trough keeps a pen from rolling off. The whole part measures 100 x 66 x 42 mm and needs no supports.
Desk-Side Screw-On Pen And Scissors Caddy
A caddy that screws to the side of a desk, pedestal or monitor shelf and keeps pens, scissors and a ruler within reach without using any desk space. It measures 124 x 25 x 42 mm and has two 13 mm pen wells, a 24 x 9 mm scissor-blade slot and a 34 x 4 mm ruler slot. Two side ears take #8 wood screws or M4 bolts through 4.6 mm holes.