Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Phone Stand With USB-C Cable Pass-Through
A 100 mm tall, 56 mm wide desk phone stand with a 65° backrest and an open triangular frame to keep plastic use low. Its 12 mm deep seat takes phones in thick cases. A 12 mm slot runs down through the seat into a 10 mm channel under the base, so a USB-C or Lightning plug stays in while the phone stands and the cable comes out the back, not off the front edge of the desk.
1/2 in EMT Phone Scan Stand Base
This is a U-shaped desk base that turns an offcut of 1/2 in EMT conduit (17.9 mm OD) and a clamp-on phone holder into an overhead document-scanning stand. The 170 x 170 mm footprint has a paper-stop lip and screw holes for #8 screws (4.5 mm). The 45 mm socket has an 18.4 mm bore with gusset ribs on both sides, and the post is locked by an M4 thumbscrew threaded into a brass heat-set insert (5.5 mm bore).