Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Under-Desk Power Strip Cradle
A screw-up bracket that lifts a power strip (or a laptop brick) off the floor and onto the underside of a desk or bench: two 15° V-arms self-centre any body 38–52 mm wide, and a 4.8 mm zip tie cinches it down through four slots, its loop hidden in a 2.2 mm groove milled into the desk-facing side so the plate still sits flat. 68 x 32 mm footprint, 31 mm tall, two 4.5 mm counterbored holes on 26 mm centres for M4 or #8 screws. Print two and space them along the strip.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
Under-Desk Cable Management Tray
A 145 x 60 x 28 mm screw-up tray that mounts to the underside of a desk to hold a power brick, surge strip and cable slack off the floor. Cables snap in through a 46.8 mm mouth under a 45° retaining lip, both ends are open for pass-through, three vented windows per side let cables exit anywhere, four zip-tie slots strap a brick down, and four raised pads take M4 (or #8) screws in 4.5 mm clearance bores with 8.4 mm counterbores so the heads sit flush below the cables.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.